JEllie Beans VR Tracker Case and Calibration Stand (SlimeVR)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A single board VR tracker based on the SlimeVR project. This is all the case files and files required to order from JLC.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Required Hardware for each unit:
- 3 M2x3x3.5mm threaded insert
- 3 6mm m2 countersunk bolts (ISO 14581 or at least countersunk screws)
- 1 900 mAh 3.7V 103030 lipo battery with PH 2.0 plug
- USB Cable for flashing/charging (Obviously can be reused)
- Either 25.4mm/1in elastic strap with matching clasp, or purchase straps similar to EOZVR that use a thread.
At least one calibration base and threaded base must be printed so you can calibrate the IMUs in the SlimeVR software. For basic calibration instructions, follow the steps documented for the BMI160 IMU: https://github.com/SlimeVR/SlimeVR-Tracker-ESP/blob/main/README.md
If you need further details on calibration, the SlimeVR discord server is a good resource.
Firmware flashing(use chrome):
https://slimevr-firmware.bscotch.ca/
Details are in the photos, but here is the text form:
Version: kounocom/sfusion-tuned-mbe
Board:Lolin-C3-Mini
SDA pin: 4
SCL pin: 5
LED pin 10
IMU BMI 270
☑Enable LED
☑LED Inverted
☐Swap IMU Addresses
☐Secondary IMU (unless using extensions)