Elite Gourmet Dehydrator Dryer Extension Ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dryer Extension Ring (175 mm tall) for the Elite Gourmet EFD319BNG food dehydrator.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
1 piece print and just fit on my QIDI Plus 4 build plate (NEEDS 299mm minimum X & Z). STL and STEP files included.
The extension ring could be scaled down to about 50-60% in the Z-axis and still work if you do not want a 175 mm tall extension ring. Note - V2 files are uploaded and has a stiffing rim top and bottom that you will notice my printed version does not.
I printed in Sunlu ABS with .4 nozzle and .2mm layer height.
I added a 3mm brim to the interior (interior is easier to trim with deburring tool). Use your judgment based on your typical adhesion results if you feel like you can go without the brim.
On my QIDI Plus 4, used generic ABS settings but changed - 55C chamber, 260C nozzle, 100C bed.
I printed mine @ 100% expected these to shrink a bit, but they did not by much. My parts are slightly loose on the bottom and more snug than I'd like on the top. If I were to print these again (on my machine) I'd probably scale the X & Y to 99.5%, but if you typically experience Costanza level ABS shrinkage on your rig then 100% (or more) may work better for you.