1 / 2
3/4" Screw to Hose Pipe Flange
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is a 3/4 inch screw to hose pipe flange adapter for an Arlec 8000 BTU drainage port. This default pipe needed for water drainage is 3/4" pipe, I wanted something that would use a hose pipe (~15mm) as I had this spare.
For water tightness put a rubber or plastic washer at the end of the screw.
V4: Change hose flange max diameter from 14.5mm to 14mm as 14.5mm was a bit tight. Increased hose flange chamfer from 4mm to 5mm for added strength at base of flange.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 S1
No
Supports:
Yes
0.2
Infill:
20
Category: Parts