Floating paintbrush holder / stand for miniature painting etc.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy / fast to use paintbrush holder that doesn't use an excessive amount of filament.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted an easy to use paintbrush holder that doesn't use an excessive amount of filament. With this holder you can take out and put back brushes very fast without worrying about alignments etc.
Just choose the right hole diameter and drop it in. It's supposed to 'float' from the ground. Some brushes will still touch the ground but that's ok.
The tolerances are tight and you don't need glue. But the 6 extended connectors from the plate do need the bottom layer to be trimmed a little or else it won't fit. This is also called 'elephant feet' in 3d printing terms. After trimming the bottom edges/corners you can push it in a little and carefully slam it in further on your desk for example. (I laid it down on it's side with the plate sticking up in the air and then just up and down motion).
Print settings
0.2 mm layer height with a 0.4 mm nozzle.
Please post your makes and let me know in the comments what you think!
