HDZero TrueRC X-Air brackets and thumbscrews by Fourflies
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
HDZero Goggle rail brackets for TrueRC's X-Air antennas with clip attachment, foot supports, and large thumbscrews.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 77
- Wydruki
- 3
- Wyświetlenia
- 326
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
These brackets feature some enhancements over other designs:
X-Airs are held in place by clips. No adhesive or tape.
Feet added to the bottom of the brackets supports the goggles and prevents the focus adjust wheels from touching.
Curved cutout for the coax cable supports a gentle bend angle.
Thumbscrews with large diameter and sharp grip.
Light weight, low profile, with a snug and firm fit.
The photographed samples were printed by JLCPCB in PA12 on their MJF printers. Untested in any other printers. Feedback appreciated!
A pair of brackets are <9 grams, and a pair of thumbscrews are <1 gram.
Also available at OnShape:
2026 UPDATE:
bracket-left-g2 and bracket-right-g2 variants have been added. These have 6 mm longer feet, intended for the larger diopter adjust knobs on Goggle version 2.
thumbscrew-8.2 variant added which has a slightly larger cutout (8.2 mm vs 8.1 mm) for a looser SMA connector installation.