.45 ACP Waterproof Ammo Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Waterproof ammo box for .45 ACP, holds 50 rounds
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 211
- Wydruki
- 0
- Wyświetlenia
- 870
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Hello, this is an ammo box designed for .45 ACP rounds. It is a waterproof and rugged box for long term storage, and also compact enough to bring to the range.
Print Settings:
Base and Lid - PETG or ABS recommended. Increase top and bottom layers to at least 1mm think to increase drop resistance.
Latch - PETG recommended. Print 100% Solid. This part requires a little give to it that gives it that satisfying snap.
Seal - TPU required to get seal correctly. Seal isn't required, but the ammo box will not be waterproof.
Parts Required for Assembly:
4x 3x20mm Hex cap screws
4x 3mm Hex nuts
3D Printed parts
Assembly steps:
- Insert 3mm hex nuts into the lid and the base 3d prints. There are hexagonal cut-outs for the nuts to be pressed into.
- Slide the lid on top of the base. The hinge section will only align in the correct orientation. Use (2) 3x20mm screws to secure the lid onto the base.
- Attach the latches onto the lid, following a similar procedure.
- Test the opening and closing of the box to ensure the screws aren't too tight as to restrict movement.
- Open the box, insert the seal around the inner race of the base. It should seat and stay in the base.