Biblical accurate angel (collapsible)

✨ Biblical accurate angel model ✨
Always wanted to create a model like this and after some testing there are now two versions. Would love to hear what you think of them!

✴ No Glue Version  (Collapsible) ✴
🖤 Support free 
🖤 Print at 0.15 mm layer height or smaller, 15 % infill (gyroid) worked well for me
🖤 Test prints all done at 100 % - largest ring has a diameter of 20 cm 
🖤 All rings rotate and collapse 
🖤 No guarantee sizing down will work -  if you still want to try, consider using a smaller nozzle size as well
 

✴ Glue Version ✴
🖤 Support free
🖤 Print at 0.15 mm layer height or smaller, 15 % infill (gyroid) worked well for me
🖤 Test prints all done at 100 % - largest ring has a diameter of ~20 cm 

🪛 How to glue them together
Each ring has 2 grooves to add the glue and the next smaller ring has 2 pins that go into these grooves. Use them for proper orientation. Gluing the rings together otherwise won't work due to the distance between the rings. I used "Kraftprotz Sekundenkleber 3D Druck" - Gorilla Glue and similar will likely work perfectly as well

If you want to get the exact orientation as in the pictures proceed as follows:

1. Start with the two smallest rings and glue them together at an angle of 60°
2. Add the next bigger ring and also glue it at an 60° angle. All three rings should be evenly spaced now! 
3. Add the biggest ring at an 90° angle to the second biggest ring to complete the assembly

The Glue Version as a tree topper addition/mounting option available here!

The prints seen in the pictures were done using the Prusa MK4S and eSun in Gold. 

The rings of the Glue and No Glue versions rotate a bit differently (as visible in the pictures)

Happy printing! 🖤

Note: I get an error message in PrusaSlicer 2.8.1 that the dimensions are defined in meters instead of millimeters. If the same happens to you just click “Yes”. I will try my best to fix this in updated versions.