ATLANTIS for MiSTer - USB hub housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Supports various configurations and modifications to the 4-port USB hub board for mounting on ATLANTIS for MiSTer FPGA
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This USB hub housing is intended for Micro-USB OTC 4-port USB type A hub boards; with the following form factor:
NOTE: You must ensure the board utilises the HS8836A IC USB hub controller (some similar appearing enclosures house hub boards with different components that may not work correctly with MiSTer).
The original enclosure can be pried apart to remove the board and cable. Insert it into the 3D printed part with a solid surface (which forms the top).
To fix the USB hub onto the hub mount plate:
- Place 4x 25mm M3 bolts into the top of the USB hub to keep the corners aligned (Figure 13).
- Run the micro-USB cable underneath the hub stack.
- Align the USB hub corner holes with the hub mount plate corner holes.
- Secure the M3 bolts into the 8mm threaded hex spacers underneath the corresponding corners of the mount plate.
In addition, a header standoff is included if you intend to modify the hub for directly connecting PC case internal USB connectors via IDC 10 way right angle sockets (remove the pins along one edge and re-insert them so they “straddle” the header standoff).
