Creality K1-Series Btt SFS V2 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Creality K1/K1c filament sensor spacer for better filament feeding from Dryers such as Sunlu v2
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 503
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
BOM:
- connector 2x - PH2.0
- 1x - smd 0201 100R resistor
- screw 4x - M3x6
The kit includes XH2.54 connectors, you need to change them to ph2.0, Crimping Tools is required.
Installation of a resistor 100ohms, there are 2 options for further implementation
Option one, install smd 0201 100R resistor, i circled the installation location in the photo
Option two, install a regular resistor like CF-100 in the gap of the blue wire, and close everything with heat shrink, the resistor rating is 100 ohms
Klipper settings:
[filament_switch_sensor filament_sensor]
pause_on_runout: true
switch_pin: ^PA7
runout_gcode:
{% if printer.extruder.can_extrude|lower == 'true' %}
G91
G0 E30 F600
G90
{% endif %}[filament_motion_sensor encoder_sensor]
switch_pin: ^PC15
detection_length: 5
extruder: extruder
pause_on_runout: true
runout_gcode:
{% if printer.extruder.can_extrude|lower == 'true' %}
G91
G0 E30 F600
G90
{% endif %}
Print without supports
I got the installation information here
BigTreeTech smart filament detection module github
P.S.
I used what was available smd 0805 100R resistor
