1 / 2
Ikea UPPSPEL and SKÅDIS Drone fpv holder slightly wider version
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printed the original but was just a bit too narrow to hold the arms on the 5" i am building. Widened 10mm each side.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 135
- Wydruki
- 2
- Wyświetlenia
- 952
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (1)Kolekcje (31)Powiązane
Remixed the original to work with a 5" i am building, seen some remixes which added more depth but not width and the original one would just about fit the width of my frame (Speedybee Master 5 V2) but was too tight to rest under the arms so just added 10mm to each side and worked perfectly. Thanks to @Skyline989 for the original to work from.
Printed as is with supports 50% infill.