Printed Screw for Self-Adjusting Gripper Plywood/Panel Carrier Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The screw printed flat were most likely more than sufficient in terms of strenght for the Carrier Clamp
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 769
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
If you want this gripper go here: this here is only the printed screw that is used it in.
This is just an addon to the nice panel carrier grip. Finding the metal screws in Europe turned up to be quite expensive and ridiculously complicated unless you buy 100.
- This is a printable screw flat on the surface.
- Yes it looks a bit weird because it's truncated but believe me this works perfectly fine
- It made no sense to keep the original format of the metal bolt so I made them bigger so it's easier to turn with your hand.
Tip for printing:
- A printed screw is very finicky too print. I was never able to print the original on my bambu X1C.
- I am providing different tolerances for the bolt so you can just print them all and see which one fits.
- For the Bambulabs the **default - bolt(0.25 tolerance) worked for me
- Bambulabs settings (sorry I don't know the other slicers)
- Under Quality: Wall Generator: Arachne
Printed in PLA - solid - 0.2mm
---------------------
Tips about the grip
Printing in TPU is a nightmare, so I went along with those anti-slip carpet things that I bought at Ikea for very cheap. I just sticked them with double sided tape.
And another tip - if you have thin panels, make it ticker with a towel, or as you see on my picture some more anti-slip carpet thing. The grip is way stronger.
Finally - I imagine you could also glue 40 grit sand paper on those for hard gripping ;)
