Wyze Cam v3 Magnet Mount

This mount replaces the stock mount on a Wyze Cam v3 using the original mounting screw.

Non-printed required parts

• m3x10 screws (4x)
• m3 hex nuts (4x)
• 15x2mm round magnets (3x)

Printing instructions

• Material doesn't matter. I used PLA.
• 0.2mm layer height
• 15-20% infill
• Print the base with the flat side on the bed. Depending on your printer's bridging capabilities, supports may be needed for the ceiling of the magnet holes. The vertical holes in the arm mounts are tear dropped, so no supports should be needed.
• print the cam mount with the flat side down. No supports needed (vertical holes are tear dropped on this too).
• Print two arms. Print them with the flat side on the bed. Supports are recommended for the ceiling of the countersunk screw holes.

Assembly

• Use the mounting screw that came with the camera to attach the new mount. If you're missing this screw, a similar standard tripod/camera mount screw may work.
• Arms go on the outside of the arm mount points. The protruding rings on the arms fit into the recesses on the arm mount points. Use the pictures for reference.
• Hex nuts should get pulled into their recesses when the screws are tightened.
• Magnets should be glued into place. Be careful not to let the magnets pop out and stick to each other while gluing them. I recommend gluing one at a time and waiting for each to dry a bit before moving on to the next one. CA glue and accelerator works great here.

Additional

The Fusion360 project file is included in case edits need to be made. Notably, the magnet_* and hex_nut_* parameters can be changed to accommodate different sized nuts and magnets, or if you require different tolerances.