Ford Radio Handset Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Microphone hook for a Ford Radio Handset
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
This is a 3d model of a Radio Hook that would be installed in a Ford vehicle to hold the CB radio microphone handset.
The size is a little large to accommodate for hand finishing. It just needs some sanding to ensure a good fit.
Experiment with print orientation and settings to make sure the print is strong enough to hold your microphone. I printed it flat with several walls and it held up pretty well. If the microphone was slammed down on it though, it might break.
Also make sure that the material used can withstand the higher temperatures that are seen in the inside of a car. PLA for instance starts to soften at around 140F (60C).