Yet Another LCR-T4 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Toolless Case for LCR-T4 meter Available with and without hole for switch
- Ocena
- 2,5 / 5
- Polubienia
- 15
- Pobrania
- 179
- Wydruki
- 2
- Wyświetlenia
- 895
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Finally decided that the LCR-T4 meter rolling around on my desk needed a case.
Wanted a "toolless" case, so here it is.
I used this switch from jaycar: ultra-mini-rocker-switch.
Model is based on this case by Phenomen however this is a complete redesign.
Please check dimensions before testing, to make sure the case will fit your board. Component Tester Dimensions
(all dimensions in mm) DRAWING NOT TO SCALE
<-----------71.25------------->
_ _ -------------------- _ _
∧ |<7->| | \ | ∧
| | | | | |
38.4 | | | | |
| | | | /| |
∨ | |_ _ _ _ _ _ _ _ _ | / | 63.10
| ∧ 9.8 <-7>| |
|_ _ _ _ _ _∨ | |
∧14.9| | | |
∨ | _ _ _ _ _ | _ _ _ _ _ _ _ _| ∨
<----33.00--->
<>
1.53mm (ZIF socket extends from the pcb)
Printing:
- Top printed face down without supports
- Base printed Left side down with supports
- Default Cura settings otherwise(20% infill @ 0.2mm layer height)
Top should give a snug fit to the board, there is a lot of variance in assembly of the boards (the display is askew on mine) and it was designed with this in mind. But it may not be perfect.
Bottom right of the board isn't given a lot of support apart from the snug fit.