Simple Elevated iPhone Magsafe Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple 3-part print for an iPhone Magsafe mount.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 76
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple 3-part model for an iPhone Magsafe mount. It's made to be used with an official Apple Magsafe puck, although third party pucks could work if they're the same size. The mount elevates the phone approximately 4.5 inches off the surface, and angles it 15 degrees back. Great for Standby mode!
Double sided tape can be used to attach the puck to the mount, and there is a 3mm hole in the back of the “bulb” to assist in popping it back out with a hex wrench or something similar. The model prints in 3 pieces which need to be glued together. A snap-together version might make for a nice modification!