Hot sauce six-pack stand

In my quest to clean up our fridge, I designed and printes this practical hot sauce holder. It holds 6 bottles with a diameter under 50mm. I can't guarantee that everything will fit, but this seems to fit most standard hot sauce bottles. Measure and increase or decrease the scale of the model as needed. 

You can easily take one bottle from the fridge, without having to search for it. Or take the whole set from the fridge to the dining table or barbeque.

I hate wasting filament, so I tried to make it as economical as possible.  

Print instructions:

Designed for easy printing. Print on its back (as is), no supports required. 

Scaling for other bottles:

The stand is desiged with hot sauce in mind, but can easily adapted for other bottles or even cans. The holes for the bottles are 50mm. Use that to calculate the scale.

Some suggestions:

• 62 mm would fit (most) 330ml beer bottles. That would be 124%, in all directions.
• 135% would make a holder for cans, only scale in X and Y.

Note: these are untested, as they don't fit the buildplate of my Mini+. I suggest measuring before printing, leave 1 or 2 mm of space, you don't want too tight of a fit.