Prusa MK3 Y-Rod holder (uses original hardware)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
(- Update - 5. 6.
- Ocena
- 4,5 / 5
- Polubienia
- 25
- Pobrania
- 474
- Wydruki
- 0
- Wyświetlenia
- 3652
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
(- Update - 5. 6. 2019 - y-rod_holder_part_2_for_2-3mm_thick_nut.stl has been added for square nuts with thickness of 2.3mm)
(- Update - 21. 5. 2019 - y-rod_holder_part_1 has been updated with lower brace that inserts into the aluminum extrusion T-slot)
(- Update - 17. 5. 2019 - Better spacing between part 2 and the Y-carriage, Square nut slides into Part 2 a bit better force is still needed for a snug fit)
Print using 9 Perimeters.
Use supports from bed only
This Y-Rod holder clamps the rods securely and uses the same hardware as the original mk3 Y-Rod holder.
--Assembly--
-The square nut slides into Part 2 will require a little bit of force.
-(IMPORTANT STEP - Snap part 1 and 2 together and screw it tight to seat the nut proper)
-You will need to squeeze the sides when screwing to the frame
Print instructions
Print using 9 Perimeters.
Use supports from bed only
--Assembly--
-The square nut slides into Part 2 will require a little bit of force.
-(IMPORTANT STEP - Snap part 1 and 2 together and screw it tight to seat the nut proper)
-You will need to squeeze the sides when screwing to the frame