1 / 2
6mm GT2 Belt Joiner for 8mm Grid (goBilda) Viper Slide and Similar Use Cases — zdjęcie 1
1 / 2

6mm GT2 Belt Joiner for 8mm Grid (goBilda) Viper Slide and Similar Use Cases

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Printable hardware for creating a butt joint between 6mm GT2 belt ends.

Ocena
0 / 5
Polubienia
1
Pobrania
13
Wydruki
0
Wyświetlenia
182
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Share Alike

Hopefully this is simple and will just work for most cases. The raised bit in the middle is so that the screw into the threaded 5x1 pattern plate will apply pressure downward against the belt without having to go through it.

To use, print as a structural part. Meaning 4 or more walls and maybe 5 top and bottom layers. Then, pinch the rough side of the belt against the rough side of the joiner and screw it down. Use very tight zip ties toward the ends to really lock it in place.

This is just short enough to work in a goBilda viper slide, and saves just enough belt length to repair a belt that breaks at a prior end attachment.

 

SUPPORTING YOUR FAVORITE DESIGNERS:

The Amazon links below are affiliate links, and it costs you nothing to use them. If you use an affiliate link to get to Amazon the next time you need to buy something, the designer associated with that link will get a small percentage of any sale made during that browsing session. I hope you'll pick a designer here once in a while to support in this way. Frankly, it tends to be more symbolic than anything, but it lets designers know that you connected with their designs, and it feels good.
 

BOM: 

INSTRUCTIONS:

  • Print.
     
  • Put together as in the photo.
     
  • Rule the world.
     
  • ‘Likes’, ‘Follows’ and ‘Downloads’ all help to elevate goods designs, like any other social media. If you like a thing, please click ‘like’.

 

Tagi