Pnuematic Chair Height Lock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fix for chairs that sink due to worn-out pneumatic cylinder.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 364
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Does your office chair have a flat? When you sit in it does it slowly sink to the floor? If you answered yes to either of these questions then this is the fix for you.
These are spacers meant to keep your chair from sinking. Print and combination of the STLs to achieve the desired height. You'll need an m6x50 bolt and nut to secure the spacer from accidentally popping off as you roll the chair around. I also
It's a re-mix of Enigma644's "Office chair pneumatic cylinder fix clip" found on Thingiverse. Requires an M6x50 bolt and nut (or similar length).
Updated by:
- Adding way to secure to chair with bolt
- A way to line up multiple spacers to prevent spacers from turning in different directions