M200 electric toothbrush flex holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall attached single toothbrush holder using the natural flexibility of plastic for retention. Stick with thick tape
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This holder is made specifically for the slim electric toothbrush model m200 (its sold under many names on aliexpress and such) however, it may very much fit anything that's similarly sized (13-17mm diameter)
It can actually hold a lot more stuff than i expected, even objects which aren't round
I found my failed print can even hold a toothpaste tube (as long as part of the paste is squeezed to side) - You could do the same but removing some of the top layers in the slicer until the circle is open
HOW TO USE:
- Place your toothbrush bottom into the bottom surface.
- Press the upper part of your toothbrush into the bracket - Its better to hold it firmly or the pressure release smacks it against the wall
- Done! Reverse the same operations to get it out
DESIGN:
Current version has a 20x40mm backplate for easy adhesion using thick 3m transparent double sided tape, which seems to hold up well in bathrooms.
If you need, you could drill holes through and attach it with a screw (don't use sunken head screws though, those would break the layers apart)
I made the toothbrush to be about 1cm away from the wall which seems to be enough for the bristles to not touch it.
HOW TO PRINT:
No special printing instructions needed