Smart Tag 2 Rigid Case

• Designed for PETG. Don't forget to rescale if you change material to TPU 95A (I recommend to start with a factor of x1.02)

• Design allows for more temper-proof installation, because the screws can be contained

• Case Dimensions: 80.8mm X 37.0mm X 12.0mm

  • 4mm wall thickness should grant sufficient protection for your tag

• Case can be sealed by inserting 205mm of 1.75mm diameter TPU filament

  • screws are also contained within seal to prevent rust

• Tight fit and zero-rattling. You can only get the tag out of the case with a tool. I recommend a pair of angled pincers (see image)

• One version for M4 heated inserts, one version for M4 nuts (pause print and insert nuts)

• 2 to 7 heated inserts (M4, up to 8mm deep) OR 2 to 7 M4 nuts

  • + the respective M4 screws

• Has a little compartment for the battery replacement wire that comes with every tag. That way you have the tool available when you change the batteries

• I was asked to add a version wood screws. It's designed for a screw with a head diameter of 8mm, and 4.2mm body diameter. (+0.2mm tolerance)

  • You will need two of bespoke screws which will be screwed through the case

My designs are released under a public domain license: You can do whatever you want with it. I put as much care and attention to detail into it as if it was a commercial product. If my design solved a problem for you, I'd like to invite you to donate me a quarter of a filament spool. These little gestures go a long way and are quite motivating. Thank you!