Easy Studio for gadget photography
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easy studio to take photos of your own makes or when you want to show your version of a print.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 912
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
An easy studio to take photos of your own makes or when you want to “Post a make” of your version of a 3d print that you have downloaded.
A attempt to make a small studio for taking pictures of prints that is going up here on Printables. The only limitations I hade for this project where that it hade to be useable on the edges of a table.
I used a white cotton sheet and some random lights that i have hade in storage. To fasten the cotton sheet i used two clothes-peg. The height that I used was 50 cm and a width of ~100 cm front and back. Glue the vertical holder on top of the clamp, but check so you position them the same way. After some consideration I made a decision that gluing the holder to the clamp i the way to go., this gives it more flexibility to make them as needed.
The clamp comes from the maker 247generator on Thingiverse, If you need to make a custom clamp he have a SCAD generator available. https://www.thingiverse.com/thing:3075868
The aluminium profiles i have used is described here:
Aluminium U-profile
A: 20 mm
B: 2 mm
C: 1 mm
D: 18 mm
Aluminium angel profile
A: 10 mm
B: 10 mm
C: 1 mm