Mini Skateboard Display Stand For Tech Decks
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple way to display my mini/fingerboard Rob Roskopp Santa Cruz Tech Deck without hiding the graphics.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 109
- Wydruki
- 0
- Wyświetlenia
- 411
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple way to display my Rob Roskopp Santa Cruz Tech Deck without hiding the graphics on the tail. This is super minimal to maximize how much of the deck can be seen and because it will be in an area that won't be disturbed much.
I'm new to 3D modeling and thought this would be a good opportunity to practice making something practical. As this was measured specifically off the Rob Roskopp board, I doubt it will fit others as well without modification, but maybe it will inspire you to make one too.
Printed in PLA, no brim or supports, with a .4 nozzle and .2 layer height, 10% gyroid infill. It used 4.01g / 1.39m of filament.