Snapmaker 2.0 5015 Fan Part Cooling (Klicky Mod Compatible) - Modified
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
5015 fan cooling duct for Snapmaker 2.0 v2 printhead, compatible with Kilcky probe mod.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 188
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is actually a small remix of the Klicky mod compatible 5015 cooling fan mod parts found at https://www.printables.com/model/532038-klicky-probe-for-snapmaker-20-single-extruder/files, which are in turn a remix of the original that I have also linked to here.
Print Settings
**Rafts:**
No
Supports:
Yes
**Resolution:**
0.2
Infill:
40% Gyroid
**Filament:** Overture ASA Black
Notes:
Print the outlet duck in a high-temp filament; ABS/ASA or better is preferred; PETG may be ok. When printing with ABS/ASA, be sure to add 0.6% shrinkage compensation factor for proper fit. Supports are needed in various spots, but use support blockers to prevent supports from printing inside the duct and outlet ports where they will be very difficult/impossible to remove.
Use M3 x 5mm outside diameter x 4mm length heatset inserts in the two holes on the back of the outlet duct.