1 / 3
Benriner BN-1 mandoline safety cover and blade holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cover for the Benriner BN-1 mandoline to keep the main blade covered in drawers, and to store the three julienne blades
- Ocena
- 4,5 / 5
- Polubienia
- 8
- Pobrania
- 94
- Wydruki
- 2
- Wyświetlenia
- 659
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (1)Kolekcje (14)Powiązane
I created a cover for my Benriner mandoline to allow me to keep it safely in drawers without worrying about cutting my fingers. It worked so well I thought I'd share it. It also has storage for the three julienne blades that came with it.
This is designed to fit the 64mm width of the Benriner BN-1, I haven't tested it with any others.
Requirements:
- Magnets - 5mm diameter, 3mm depth
Printing advice:
- Will require supports for the bar which holds the julienne blades in place.
- The edge chamfers are 45 degrees so should not require bed supports.
- Prints great with standard PLA using 20% infill.
- Tolerances for the magnets should already be made.
Features:
- Clips securely onto the blade of the mandoline using magnets.
- A bar covers the cutting edge of the blade so it isn't exposed on the underside either.
- That same bar holds the three julienne blades which came with my mandoline in a slot. Add and remove the blades one-at-a-time from under the bar.