1 / 3
Smol Table
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small side table with 3d printed legs and a wooden tabletop
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A small table with 3d printed legs and a wooden tabletop.
Print settings:
- 0.16mm layer height
- 10% gyroid infill to save on filament
- leg base needs supports
- printed with PLA
In addition to the printed parts you will need:
- A wooden tabletop, I recommend ~30cm diameter ~18mm thick, e.g. this one from eBay or similar
- 16 Countersunk screws, I recommend 3.5mm x 15mm, e.g. these ones from Frantos
What to print:
- (Optional) Positioning guide. Can be placed on the tabletop for easier positioning of the leg bases
- 4x table leg
- 4x leg base (could be printed on one plate, but I recommend printing at least one separately to test if it screws in well)
All parts required a little bit less than a Bambulab role of PLA filament when I printed mine.
Assembly:
- Mark the position of the holes (optionally using the guide)
- Pre-drill the holes so that the wood does not split later on
- Important! Remove the guide before screwing in the leg bases, otherwise you will have to destroy the guide to remove it
- Screw the bases into the wood using the countersunk srews
- Carefully screw the legs onto the bases. Once they are on, the are sturdy, but you can break the base if you apply pressure sideways while screwing on the legs!