1 / 3
Bambu Lab P1S Air Scrubber - Aux Fan Replacement
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a drop in replacement for an aux fan housing, which accepts a tray with activated charcoal.
- Ocena
- 1 / 5
- Polubienia
- 12
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 590
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 1) (Komentarze: 5)Remiksy (0)Kolekcje (13)Powiązane
Since I print a lot of ABS/ASA, I don't have a need for the aux fan but would use an air scrubber. So I remodelled the aux fan housing body, which accepts a tray with activated charcoal.
Print with PETG, ASA or ABS. PLA would not withstand the internal temperatures. Don't forget to remove the internal sacrificial part at the fan exchaust port.
Installation:
- Remove the existing aux fan by following the official documentation – https://wiki.bambulab.com/en/p1/maintenance/p1s-aux-cooling-fan
- Remove the fan from its original housing and install it to the one you've just printed. It is possible you might need to use only two screws for the fan to properly align, this is fine.
- Remove the rubber antivibration gaskets from the outer mounts from the original housing and install them to the new one
- (optional) Use electrical tape or something else to seal the path between the fan exhaust and the new housing. This will help with airflow.
- Install the new housing following the steps from step 1 in reverse.
- Fill the tray with activated charcoal (e.g. https://amzn.eu/d/2MFknRT) and put the lid on top of it.
- Insert the tray to opening on top of the housing. It should fit snuggly.
- Enjoy fresh(er) air.
Feel free to remix the project, I attached .step and .f3d for easy editing.