Quick release display mount for ASUS ProArt PA148CTV
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A quick release mount for you ASUS display at home. Cable routing on the back.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I found the integrated tripod screw on the display not practicable for home use. My solution is this stand, where the display could be installed an removed in seconds. The cables are mounted on the back.
In my use case it's a third monitor above the big ones. I used a desk mount for installation. For mobile use i just disconnect the two cables and take the display of.
One downside is the low stability of the display housing. Depending on the angle you use, there are some effects on the display. This could be seen if the display is full black.
Unfortunately it's to big to fit on a standard sized Prusa print bed. Therefore i divided it in two parts with PrusaSclicer. I recommend to place the joint not in middle. No supports required. I used PETG, but other materials should work as well.
Additional parts are one ¼-20 melting insert and two cable ties 3,5mm.