Round adhesive Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this hook to be not sharp zo minimize injuries, because it's main purpose was to hang things like small backpacks for my daughter.
Now I use it everywhere in the house, f.E. also for towels or something an mostly on childrens height.
At the moment, there is a 35mm and 45mm version.
I don't know how much weight it can hold but you can improve it by increasing the perimeters or infill.
I use some 3M adhesive tape, which is about 15mm wide. It's not necessary to cover the whole backside, for me 1 stripe was always enough.
If you think “thats much material for just one hook”. Thats right, but yeah, its ok for me.
My Print Settings/Instructions
No special print settings or supports needed. Use a default setting from prusaslicer. I printed these with as much layer height as I can and it's also possible with a 0.6mm nozzle. I believe it would be possible with a 0.8mm nozzle without any Problems.
There are also only 45° angles so you don't need supports.