Tamiya DT-01 -- Rear body mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement for the rear body mount on a DT-01.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a printable replacement for the rear body mount on the Tamiya DT-01, in particular the 2 hole mount (so far). I believe there to be four variations:
- 1 hole, as used on the “Rookie Rabbit”, single part.
- 2 hole, as used on the “Fighter Buggy”, single part.
- 1 hole, as used on the “Mad Bull”, two parts, to fit the Grasshopper II shell.
- Elevated 1 hole, as used on the “Mad Fighter”, single part.
Unfortunately, I've not got reference for the Mad Fighter nor Mad Bull mounts. Since the 1 hole and 2 hole single part variants locate the post in the same position, a single file covers both.
My version is a direct replacement (it differs, but matches the fitment of the original), though lacking the hanging clip (I'm not sure what it does, if it's of consequence I can add it).
Printing
I recommend printing this in PETG, with a layer height l ≤ 0.2mm with supports, as most orientations leave a hovering section. Due to likelyhood of breaking at layer lines, I would suggest printing the part on its side.
Post Print
You shouldn't need to do any major cleanup. Depending on orientation, you might have to clean up the post a little bit, or the supports inside the raised area. You may need to clean up the body pin holes with a 1.5mm diameter drill bit.