Not Another Splendor Box!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a smaller Splendor box for travelling, and couldn't choose from all of the offerings, so made my own.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Years ago I gave Splendor as a gift, and printed a box from Thingiverse because I had to fly internationally to gift it.
Last week, I wanted to do that again, couldn't choose from all of the options.
So, I decided to make the situation worse by redesigning my own case.
What's different about this one is
- I believe it is the absolutely smallest Splendor box ever made
- The lid prints in vase mode and attaches mechanically with a press fit
Printing Notes
- The lid prints in vase mode. I used a 0.4 mm nozzle with extrusion width set to 0.6 mm
- Since it's a press fit, it's impossible to upload a model that will work for everyone's printer. Since it's a quick print and it's easy in today's slicers to rescale, if the model doesn't work out of the box, hopefully 1 or 2 iterations of rescaling will get you there
Usage Notes
Lid should slide on tight and then click into place.
It's a little hard to remove. I've been holding the base through the cutouts when I pull the lid off to get it started. I assume it will loosen a little over time.