Star Christmas Tree Topper - Illuminated, Translucent, Vase Mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Thin star tree topper printed in vase mode. The model is thin and hollow allowing you to put some lights inside!
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 167
- Wydruki
- 3
- Wyświetlenia
- 728
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Introduction
This Christmas tree topper is the perfect addition to make your Christmas tree shine!
This model is designed to be printed in vase mode. It consists of two parts that must be glued together with CA glue. Because the model is thin and hollow, you can put some of your tree's light inside and let it glow through the star! The model's geometry makes it so that a smaller start shines inside the big one!
Print Instructions
This model has some challenging overhangs. It was printed from eSun-Copper Silk PLA. Both of these factors result in quite a low print speed. If you see defects try lowering the print speed even further.
Print Settings:
- Nozzle Diameter: 0.4mm
- Layer Height: 0.08mm
- Print Speed: 50mm/s
- Wall thickness: 0.4mm
- Vase Mode: Enabled
- Bottom Layers: 1
Assembly Instructions:
- The two sides of the star need to be glued together. To do this add some CA glue to the lip of one of the sides and then connect the two sides. Apply some gentle pressure for 1-2 minutes to let the glue dry.
- Slide some of your tree's light into the star.
- Slide the start on top of the tree.