KitchenAid Pro 600 Cord Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
KitchenAid Professional 600 Cord Holder. Place to coil up the cord instead of wrapping it around the neck of the mixer.
- Ocena
- 5 / 5
- Polubienia
- 40
- Pobrania
- 232
- Wydruki
- 1
- Wyświetlenia
- 1852
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
KitchenAid Professional 600 Cord Holder. Place to coil up the cord instead of wrapping it around the neck of the mixer.
Prints as 3 pieces, no supports required.
Any filament can be used.
Uses 2 M3 20 Hex heads to assemble.
Base piece can be glued on or just let the screw hold it on.
The mixer uses a short #6-32 (or very close to that) Does not seem to be metric. I used a #6-32 ¾" and cut it down to about ½"and it worked well. Just make sure the screw does not go in too far and cause and issue. There is power back there.
Note: This is what my mixer had for a screw. Yours may be different, check before you purchase a new screw!
Second note: To keep the thin metal wrap in place while you remove and replace the screw, use some blue tape ( of similar) to hold it in place as far back on the mixer as possible. Otherwise it falls off, and makes it harder to put the cord holder on.