Adjustable Resin Wash Station Mount for Mars 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Suspends the print platform from an Elegoo Mars 3 in a DIY washer for resin parts cleaning.
- Ocena
- 1 / 5
- Polubienia
- 18
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 1034
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a height adjustable rack that suspends the build plate from a Elegoo Mars 3 (may work with other variants) in a cleaning bath during the wash process. The dimensions were designed to work with a Cambro 8qt container as part of a DIY wash station.
To build the rack, you'll need:
(1) of each printed part (I used PETG, >25% infill, 3 perimeters)
(2) 1.7" (43.2mm) long, 9/32" (7.14mm) diameter rods, dowels, or similar. For this build, I used some aluminum tubing I had on-hand.
(2) M5 x 14mm socket-head cap screws
(2) standard M5 hex nuts
Assembly:
- Install the nuts in the slots on the underside of the carriage.
- Install both rods into one of the carriage arms.
- Attach the sub-assy from step 2 to the corresponding side of the carriage and secure with one of the M5 screws.
- Slide the sub-assy from step 3 into the large slot on the container mount such that the rod furthest from the carriage is in the slot and the other rod is outside of the mount (see pics for orientation).
- Attach remaining carriage arm with the other M5 screw.
To use, attach the build plate with printed parts still attached to the carriage. Clip entire assembly to side of wash container and adjust the height of the platform to submerge parts in cleaning bath.