Custom housing for Toshiba 32GB USB thumb drive
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have a couple of these Toshiba 32GB thumb drives... ... And the little latch I used to attach it to my key chain…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 102
- Wydruki
- 0
- Wyświetlenia
- 518
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
I have a couple of these Toshiba 32GB thumb drives...
... And the little latch I used to attach it to my key chain broke after three months in my pocket.
Technically all still fine, so I designed a replacement housing.
- hole for para cord as unbreakable connection to my key chain
- ident for status LED to shine through
- follows PCB form so there is no mechanical stress when un / plugging
- support for PCB in the back
top is glued shut with some drops of super glue ... let's see how long this will survive on key chain in pocket!
Print Settings
Printer Brand:
Anet
Printer:
A8
No
Supports:
No
0.2
Infill:
15%
Filament:
None PLA Blue
Notes:
Print the "top" part upside down, the is a little plateau on the under side to have a good connection to the USB connector.
Category: Computer