1 / 4
Ekko Powder Rose Pendant Necklace - Arcane League of Legends - MSLA ONLY — zdjęcie 1
1 / 4

Ekko Powder Rose Pendant Necklace - Arcane League of Legends - MSLA ONLY

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The rose necklace gifted to Powder by Ekko in Arcane Season 2 I cannot be stopped XD MSLA Printers ONLY

Ocena
0 / 5
Polubienia
46
Pobrania
271
Wydruki
0
Wyświetlenia
2060
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

The rose pendant that Ekko gifts Powder. 

THIS CAN ONLY BE PRINTED ON AN MSLA RESIN PRINTER

To finish the build you must buy “eye pins” and “gauge head pins” from online (https://www.amazon.com/PH-PandaHall-Stainless-Findings-Earring) or at your local craft store as well as “disk spacer beads”(https://www.amazon.com/Stainless-Jewelry-Bracelet-Necklace-Crafting/dp/B0D2X4SMY9). If you want the rings to spin independently, like in the show, glue can only go on specific areas. 

  1. Print out the outer ring and inner pendant on a RESIN printer. (Seriously, my model has fine detail not capable of being done with FDM)
  2. Paint accordingly.
  3. Cut your Eye Pin to 1.5cm (yes this is small jewelry work that needs pliers. This also assumes your disk spacer bead is 2mm tall). Thread the disk bead onto the eye pin and thread through the top holes. Glue the post of the eye pin to the InnerPendant using superglue.
  4. Cut your Gauge Head Pin to 1cm. Thread the pin through the two holes at the bottom. Glue the post of the gauge head pin to ONLY the OuterRing using superglue. 

Tagi