MMU3 Spoolholder Stilts - 4 Heights provided.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
MMU3 Spoolholder Stilts, four heights provided. Optional increased height in case a bend of the PTFE tube is too sharp.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 153
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
MMU3 Spoolholder Stilts, four heights are provided: 10, 20, 30 and 40 mm. Created for the injection molded Spool holder - R4.
Optional increased height in case a bend of the PTFE tube is too sharp. This can be the case for your setup if it is not as originally designed. Tubes could then make a sharper bend which increases friction in the tubes. Sometimes the bend can be relieved by increasing the height of the spool.
The stilts can be firmly attached to the spoolholder. So moving the assembly or picking it up is not a problem. You can tell when the spoolholder is properly seated in the stilts when you hear the satisfying click when joining them.
The model partially follows the interesting lines of the spoolholder.
Four different heights are provided:
- 10 mm
- 20 mm
- 30 mm
- 40 mm
Printing
- Fill density: 10%.
- Fill pattern: Gyroid.
Support
Only required for the 10 mm version!
- Support style: Organic.
- For support enforcers only.
- Paint on support:
- Smart fill with the angle set to 25%.
- On overhangs only.
- Select the 2 middle sections of the ceiling while looking up from underneath the model.