1 / 7
Volvo trunk floor panel handle
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement handle for the trunk floor of a Volvo V70 (probably other models as well)
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 397
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (13)Powiązane
In my Volvo V70 III (from 2009) the handle of the trunk floor panel broke. You can either order a replacement for ~20€ or spend a couple of hours to design an improved version, which I did.
Changelog
2024-12-10: Uploaded first public R6 revision.
Additional Parts
- 8x M3x12 or M3x10 screws
- 8x M3 washers (optional)
Printing
- Material: I used PLA but PETG would probably be better because of better layer adhesion
- Nozzle: 0.4mm
- Layer height: 0.2mm
- Infill: 15%, Gyroid
- Handle
- I printed it sitting diagonally on the straight bottom edge
- I manually painted on the support enforcers for some sections
- Brim: 5mm
- Supports: Everywhere
- Have a look at the slicer screenshot
- ClampRing
- No supports required
- The model already has the correct print orientation
- If it clamps not tight enough the ring should be easily scalable in Z direction
Assembly and Installation
When tightening the screws be careful not to overtighten them otherwise they rip apart the layers. That happened for me but since there are “enough” screws the handle still sits perfectly.