Prusa MK4 Y-Axis belt tensioner - fixed for collisions and locking
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix - now fixed for collisions and wheel locking on full tensioning.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 130
- Wydruki
- 5
- Wyświetlenia
- 677
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I love Ron's belt tensioner, but after using it for a while I realised I could no longer pass y-axis tests, and I had collisions (of the one-part belt holder variant that I was also using against the mod) when printing anything in the back 1cm of the plate.
I have shortened the housing projection, and made up for this by further recessing the movement into the housing. At the same time I doubted this would be enough so I modded the one-piece belt holder (by goldbird3) too - allowing even greater range of movement. I am not personally needing to use this though! If you want the shorter belt holder see my other models - it is published under a GNU licence so could not be bundled here.
I retained M3D's mod's also, including the ‘smoother’ design.
Be careful when first screwing the nut onto the housing - it is easy to cross-threads.
Note - this mod works well for me, using the one-part belt holder (link above), and noting that I had trouble getting earlier options tensioned enough so I trimmed 2-3 teeth from my belt… (don't tell PRUSA). I am not entirely sure it will work better for everyone, and I am unsure why the other versions cause collisions for me (maybe the trim). Either way, let me know if this is helpful and kudos to both Ron and M3D for all the earlier and much harder work!
