Tamiya DT-01 -- Damper Parts (last updated 2025/06/18)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement parts for the dampers on a DT-01 (or Rising Fighter).
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This entry should contain replacement parts for the friction dampers on a DT-01. These dampers are stock on the following models:
- All models using the Tamiya DT-01 chassis ("Rookie Rabbit", “Fighter Buggy”, “Mad Bull”, “Mad Fighter” etcetera).
- Rising Fighter (Grasshopper 2 chassis derived, using a DT-01 gearbox and dampers).
I can confirm these, though it seems they may also be stock as friction dampers for the Super Fighter (DT-02) and the Holiday Buggy (DT-02). I find that these friction dampers seem to wear away where the damper shaft exits the body, hence a printable replacement.
Updates
- As of 2025/04/11, this entry contains the front and rear damper parts, that is, it now has F3, the longer damper body.
- As of 2025/06/18, I updated the shape of F1 to be slightly more accurate.
Printing
I recommend printing this in PETG, with a layer height l ≤ 0.2mm with supports, to maintain layer alignment. Due to likelyhood of breaking at layer lines, I would suggest printing the parts with eyelets such that they're parallel to the bed.
Post Print
Due to the notch that acts as a orientation key between the parts, thorough clean up is suggested, though shouldn't be difficult.