Wrist wrest for Montech Mkey Darkness (Full Size)

I bought a full size Montech Mkey Darkness mechanical keyboard and noticed some wrist fatigue after long gaming sessions. 

The keyboard is pretty nice, but it's initial height on the bottom side is pretty high (~20mm). So the wrist needs to be angled relatively aggressive to accommodate for this, which I found uncomfortable.

I tested different sizes (height/angle and depth) for the wrist wrest and found starting with ~10mm and rising to 20mm height at roughly 70mm depth most comfortable.

Attached is a split version with a dovetail for easier alignment (see screenshot of placement and orientation on the buildplate). The dovetail is designed with some tolerance, so it should fit fine or maybe even be a bit loose. I use a tiny bit of CA glue to permanently glue both halves together.

If printing as suggested in the screenshot, the infill (both normal and solid/top infill) might be suboptimal, so I would suggest to also change the infill direction from 45° (default) to 0°.

I attached a few small and thin (1mm hight) silicone pads under the wrist wrest to give it some grip.

For those who want to print the wrist wrest in one piece on a bigger printer or if you want to split the part in your slicer, I also attached the single piece stl file.