2" hitch receiver cover pin-less TPU fitting block
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For inside of a 2" decorative hitch receiver cover from chromeemblems with internal dimension of 46x46mm and 5/8" pin
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 238
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
This is intended so that the pin can be kept safely stored with the hitch, and this cover could press into place with the TPU round nubbins popping into place on the hitch receiver's pin holes.
If you use the 3mf… I probably chose the wrong type of infill at 15%, and had top and bottom layers at 2mm with a 0.3mm layer height and fuzzy skin with 4 walls. But it's very strong, and requires strong force to press in the buttons. Bout 3 hours on a ender 3 with sprite extruder and some random temu filament speeds limited by a 3.4mm/s3 flow rate
Ignore the external red lines on the photo… that's paint after I had to shave down the outside radius of the metal part to fit the receiver.
doesn’t actually fit that great into the 5/8 pin hole so needs revision