Info Orbs - Hag Case

My version of a case for Bretr.Tech's Info Orbs.  The model has a number of pieces that assemble together.  The buttons and accent rings can be printed separately allowing different colors.  The main consideration when using this model is that the Info Orbs need to be assembled differently than Brett describes in his video (and instructions for the kit).  Instead of using a 90-degree header for the screens, I used a straight through header AND cut down the pins.  Cutting down the pins allows the screens to set more flush against the sockets alleviate the wobbling challenge that exists in the original way to assemble.   I have included a photo to show the screens mounted to the sockets on the main board for reference.  

I am also using a short USB-C Extension cable (male and female ends) as a pigtail.  By plugging the pigtail into the ESP32 it both powers the unit and allows re-flashing without opening the case.

NOTE of Caution:  Since this case model snaps together, you need to be very careful to ensure that the screens are seated into the front of the case and gently bring the halves together.  I did crack a few screens during the process of building this model.  I believe the cracking was mainly due to a design flaw in a very early version.  In theory, this one is way better.  However, please use caution to avoid damaging screens when assembling.