STM32 Nucleo-144 Half Shell with Locking Tabs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Half shell case for STM32 Nucleo-144 boards with 4 locking tabs to hold the board in place
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 443
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A half shell case for the ST Microelectronics Nucleo-144 line of boards. Check the list below for tested boards.
Many of the cases today rely on screws to hold them down. With some of the later Nucleo boards there are too many components or headers in the way to successfully use the screws. With that is mind this case was developed to hold the boards snugly with tabs. The board sits firmly in the case with little movement.
Printer & Print Settings
- Ender 3 V2
- PLA
- Sliced in Cura with standard quality profile
- No supports needed.
Tested Boards
- NUCLEO-H743ZI
- NUCLEO-H755ZI
- NUCLEO-F439ZI
While not a remix this case was inspired by
https://www.printables.com/model/816580-stm32-nucleo-144-case-with-ethernet-cutout