Tamiya DT-01 -- Gearbox Motor Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement motor cap for the DT-01 gearbox.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a printable replacement for the motor cap on the Tamiya DT-01 gearbox. The motor cap covers the opening opposite where the motor mounted, and fits in two orientations due to two small post keys on the gearbox casing. This gearbox is used on the following models:
- All models using the Tamiya DT-01 chassis ("Rookie Rabbit", “Fighter Buggy”, “Mad Bull”, “Mad Fighter” etcetera).
- Rising Fighter (Grasshopper 2 chassis derived, using a DT-01 gearbox).
As is usually the case, I was missing these from a DT-01, and so created a printable file for one. It should fit exactly as the original part does.
Printing
The file will need to be rotated in your slicer of choice such that the logo points up. I recommend printing this in PETG, with a layer height l ≤ 0.2mm with supports, as the top of the cap is otherwise floating. I print it with a 0.4mm nozzle.
Post print
Supports must be cleared, and I advise clearing the two holes which the motor screws travel through with at least a 3mm drill bit as well as the key holes with a 1.5mm drill bit, as these will likely have support material blocking the keys.