Document Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple case which is printed in TPU 80A
Note: To get texture as on photo - use some textured PEI plates, be careful as TPU loves to stick too much. For best texture - don't recommend using glue or any other bed-protecting adhesives, just take it off the bed slowly
Version 1:
needs to be stitched afterwards
also folds need to be heated with a heatgun to keep folded orientation
Current Problems:
* Folds need to be heated, otherwise it tries to open the document
* Needs post processing
* A bit too thick
Roadmap:
Version 1.1:
add cuts to folding lines for easier folding
Version 2 (WIP):
add metal or printed support material plate mid-print insert (or just print support), to make side pockets in correct orientation
Version 3 (WIP):
Print In Place case