1 / 3
Combination Wrench holder for french cleat wall 5-piece wrench set — zdjęcie 1
1 / 3

Combination Wrench holder for french cleat wall 5-piece wrench set

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A very simple holder for a very cheap box-wrench/combination 5-piece wrench set. (My metric and SAE set shown)

Ocena
0 / 5
Polubienia
7
Pobrania
63
Wydruki
0
Wyświetlenia
452
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

All of the combination/boxwrench french cleat hangers I saw were made for much nicer toolsets than I have. Not sure if this will be useful to anyone else, but maybe you can modify the FreeCAD (v1.0.0) file for your own purposes.

I left a flat spot at the top of the hanger above the wrenches for a label… maybe some year I will get around to applying a label to mine.

The two STLs I've included are the ones shown in the picture, one matched my 9-13mm wrenches, the other matched the 3/8" - 5/8" set. The names give the widths of each “slot”. I picked the sizes by measuring the “throat” of the wrench where I wanted to hang it. I found I needed to add ~0.75mm to the measured width of the wrenches to get a comfortable compromise between holding well and not gripping the wrench too tightly, but that may depend on your printer.

Printed mine with PETG with supports that had to be removed between the hanger-fingers. I printed on the side to maximize strength in the vertical direction.

Tagi