Alternative case for JMM Solutions soldering station (Ryobi One+ 18V battery)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
T12 soldering station with Ryobi One+ 18V battery
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an alternative case to suit a JMM Solutions (Australia) soldering station with Ryobi One+ 18V battery. May also suit other T12 soldering irons.
It's a great tool, but I wanted a better looking case. This design is based around one I found on Grabcad. I altered the design in Fusion to allow the use of my existing JMM face plate and on/off switch. Despite the base design being “for Ryobi 18V batteries”, I had to make many changes to the design in order to get the batteries to actually fit correctly- I've tried it with at least 5 or more different models of Ryobi One+ 18v batteries from my collection, and it fits them fine now.
The “Battery Top” part is screwed to the “Main Case- Base” using 4x countersunk 4G x 12mm screws, and the “Main Case- Top” is screwed to the “Main Case- Base” using 8x countersunk 4G x 16mm screws. The soldering iron holder uses 2x countersunk 4G x 12mm screws.
Note: The orientation of the wires soldered to the battery contacts needs to be reversed -see pic. Ideally this should be done using a second soldering iron.
The “Main Case- Top” requires supports. The “Main Case- Base” can be printed with the top face touching print bed to avoid needing supports.