Universal Remote and Controller Holder V4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Do you have a side table? Do all your remote have a width of less than 55mm? Do you have Xbox style controllers, or…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 95
- Wydruki
- 1
- Wyświetlenia
- 1356
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Do you have a side table? Do all your remote have a width of less than 55mm? Do you have Xbox style controllers, or even perhaps, a steam controller? If you answered yes to any of these questions, I have the design of the century for you.
This is a universal remote holder primarily designed for overbed tables. Universal in the sense that I took all the remotes in my apartment that I could find, measured them, found the widest one, and then made each compartment that plus 5mm. Why an overbed table? I was once in the hospital for quite some time and grew to love the little side tables they have there. As a cripple now, I designed this for fellow disabled people who also have an overbed table next to them and can't reach remotes/controllers if they fall off the table. This can fit three remotes comfortably, as well as two Xbox style controllers. This does not work with PS4 controllers, I could design something that does, but only if there's an interest in it. This uses a single #8 x 1-3/4" construction screw.
Anyway, I've included pre-sliced STL files with supports. For the controller holder parts, I used Meshmixer tree supports. Use wire cutter snips to remove the supports also.
I'm about to have major surgery done and may or may not die, so this might be my final design. I hope you guys like it.
Category: Organization