1 / 19
Spare Parts and Extension Parts for RELN Worm Factory — zdjęcie 1
1 / 19

Spare Parts and Extension Parts for RELN Worm Factory

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I got a RELN Worm Factory, which is about 20 Years old.Some Parts (the clips) were lost and I decided to make some…

Ocena
0 / 5
Polubienia
2
Pobrania
10
Wydruki
0
Wyświetlenia
56
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

I got a RELN Worm Factory, which is about 20 Years old. Some Parts (the clips) were lost and I decided to make some Improvements. The Clips simply replace the original Parts. The original water tap is not placed at the lowest Place, so that it is not possible to get all water aut of the Box. I decided close the hole with a dummy plug and to drill a new 26mm-hole at the bottom side and to fasten a garden hose. The dummy-Plug and the garden hose-adapter has 3/4" Whitworth external thread. This is the usual thread for garden hose parts in Europe. You need to buy a garden hose adapter with 3/4" internal thread to fasten a garden hose. To get the water out, you only need to hold down the garden hose. There is no need to unscrew a water tap any more. To level the whole box on uneven ground, there are parts to place a srew at the bottom of each stand. You need 4x M8 Nuts an 4x 8 x 60 screws.

All parts printed in PETG ffor better water resistance, only the seal (Dichtung) is printed in TPU. For the seal you can alternativly use a standard o-ring.

Category: Outdoor & Garden

Tagi